Skip to main content

Hyperion Camera Configuration

  • Updated

This article contains information about configuring a Hyperion Camera (model HYP-VIB9367-W or HYP-VIB9387-W). Once added to Hyperion, the camera can be used as a detection device. 

The following should be complete before continuing:

  • Minimum Gateway version: 2.6.1. Follow the steps in this article if the Gateway is on a previous version. 
  • Hyperion camera should be installed in its permanent location, powered on and connected to the same local area network as the Hyperion Gateway.

Follow the steps below to add the Hyperion Camera:

  1. Log into Hyperion at https://hyperion.wrensolutions.com.
  2. Select a location on the Organization page, then click Devices on the left.
  3. Click the Add button.
  4. Hyperion will detect cameras on the network and display them on the Add Devices page. Click on a camera in the list.
  5. Enter a name for the camera.
  6. On the right side of the screen, enter the camera height then click Initialize Camera.
  7. You will be prompted to create a root password for the camera. Enter a password and click submit (password must be 8 characters). Be sure to keep this password as it will be needed if you need to access the camera directly.
  8. The camera will be initialized. Click Add to finish adding the camera.

Refer to the attached Hyperion Camera Configuration Guide for additional details.

Please refer to the Hyperion User Guide for details on configuring automations and details on other Hyperion features and functionality.